Filter
Top Products
TO REPLACE BELT
1. Slide washers
and end caps onto
agitator assembly,
2. Install new
belt over motor
drive, then
over brush
sprocket,
NOTE: See
PARTS AND
FEATURES for
Belt Number
Motor
Brush Drive
Sprocket
End Cap Agitator
3. Place agitator
assembly back into
Power-Mate®o
4. Reinstall
agitator
cover by Iin-
ing up the
front tabs
and slots
and rotating
downward
until the
latches
Agttafor Cover
snap into placeo
5. Line up _L__
front of
\
cover and
base. Rest
cover on _.
front edge of
base as
shown.
6, NOTE: On dirt
sensor models
be sure that the
board is upright
and the wires are
tucked back as
shown.
7. Rotate cover
back. Press cover
firmly until side
and rear tabs snap
into place. Turn
Power-Mate ®
upside down and
replace two (2)
cover screws,
Cover Base
[ Top View
1. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGIfATOR CLEAN-
ING section,
Push In
And Turn
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove,
Push In
And Turn
3. Push in and turn
bulb clockwise, to
replace, Bulb must
not be higher than
15 Watts(130 Volts).
18
4. Reinstall Power-Mate e cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section,
NOTE: See PARTS AND FEATURES for
Bulb Number