Filter
Top Products
The vacuum cleaner creates suction that
picks up dirt. Rapidly moving air carries the f(
dirt to the dust bag through the airflow pas- //f _ _,
sages. The dust bag lets the air pass ./_/
through, while it traps the dirt,, Z/i / /
For best cleaning results, keep the airflow _y /,
passage open. Check the starred areas .._',_ /! Moto,
occasionally for clogso Unplug from/!/ t!t! s_r_ry\ Fl_.r
outlet before checking. Filter Exhaust
:i;:
BAG CHANGING
For best cleaning results, the dust bag
should be changed often. The electronic/
mechanical bag/hose check indicator will
come on when the bag needs to be changed
or the airflow is blocked° NOTE: See PARTS
AND FEATURES for Bag Number.
=
4. Disengage
cardboard tab from
red bag mount by
pulling away and
lifting up,
5. Pull bag out of
the red bag mount.
I. Unplug cord from
wail outlet.
2. Remove hose
from canister.
3. Pull hood release
out and up, then lift
canister hood.
Mot°r__._,_'JJ_>,___M_t:| 7// 6. Check and
Safety_._/////_/-/7// replace, if
Filter-*':/,//////////// necessary, the
",-. motor safety
(_dBag fiiter_
Mount
7. The red bag mount will flip forward after
removing bag.. This will prevent the lid from
closing until a new bag is installed,
Note: DO NOT bend or crease the middle
of the cardboard when installing the bag
into the bag mount slots.
8. Rotate red bag
mount down and
install bag into slots
per instructions
pushing down until
the cardboard tab
locks into position
and the holes align°
Tuck the bag
securely into the bag cavity so that none of it
is able to be pinched by the hood,
9. Close and latch canister hood.
10. Reinstall hose.
11. Plug cord into wall outlet,
................,.....
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc. can clog
the bag and cause it to burst before
it is full and may cause damage to
vacuum motor. Change bag more
often when vacuuming these materi-
als.
4 ............................