JVC HR-J245EA Furnace User Manual


 
EN 19
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
Repeat steps 18 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
9
Press TIMER. The recorder turns off automatically.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday–Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
NOTE:
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
pg. 21).
4
1
7
3
8
¡
123
456
7
/
8
0
9
2
1
3
TIMER
WEEKLY
DAILY
OK
q
5
/
8
23
NOTES:
The Auto SP/LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 as well as some
tapes of shorter lenghs.
Even if, in step 1, you press AUTO SP/LP TIMER and it lights
up, that doesn’t mean that the recorder will automatically
change from SP to LP mode during the course of the record-
ing. Watch the tape later to confirm.
If you have programmed the recorder to timer-record 2 or
more programs, the second programme and those thereafter
may not fit on the tape if you engage the Auto SP/LP Timer
mode. In this case, make sure the mode is not engaged, then
set the tape speed manually during timer programming.
There may be some noise at the point on the tape where the
recorder switches from SP to LP mode.
AUTO SP/LP TIMER Indicator
Auto SP/LP Timer
If, when recording in SP mode, there is not enough tape to
record the entire programme, the recorder automatically
switches to LP mode to allow complete recording.
AUTO SP/LP TIMER
ENGAGE AUTO SP/LP
TIMER
1
Press AUTO SP/LP TIMER on the recorder front panel.
The AUTO SP/LP TIMER indicator lights up.
For Example . . .
Recording a PAL-broadcast programme of 210 minutes
in length onto a 180-minute tape
After the recorder's Timer mode is engaged, make sure
the AUTO TIMER SP/LP indicator is still lit; if not, press
AUTO TIMER SP/LP so that the indicator lights.
Approximately 60
minutes
SP mode
LP mode
Approximately 150
minutes
Total 210 minutes