Filter
Top Products
872678-UIM-C-0213
Johnson Controls Unitary Products 17
SECTION XI: START UP SHEET
Air Conditioning and Heating Start-Up Sheet
Proper start-up is critical to customer comfort and equipment longevity
Name Address
City State or Province Zip or Postal Code
Indoor Unit Model # Indoor Unit Serial #
Indoor Coil Model # Indoor Coil Serial #
Upflow Downflow Horizontal Left Horizontal Right
Unit is level
Venting system properly sized, within the limitations of the charts in the installation instructions.
Condensate drain for indoor coil properly connected
Filter Type
Intake Size
Exhaust Size
# of 90 Degree Ells # 0f 45 Degree Ells Length
Length # 0f 45 Degree Ells# of 90 Degree Ells
Polarity is correct (120vac indoor units) black is L1 (hot), white is N (neutral)Ground wire is connected
Indoor unit (volts AC)
Low voltage values: "R" and "C" at Indoor unit control board (volts AC)
Thermostat Type
Other System Equipment and Accessories
Owner Information
Equipment Data
Venting (if applicable)
Electrical: Line Voltage
Outdoor Unit Model # Outdoor Unit Serial #
Filter, Thermostat, Accessories
Filter Location(s)
Connections -- Per Installation Instructions and Local Codes
Gas piping is connected (if applicable)
Supply plenum and return ducts are connected and sealed
Filter Size
Vent system is connected (if applicable)
Thermostat wiring complete
Heat anticipator is set to the recommended value listed in the Installation Instructions
Electrical: Low Voltage
Technician Performing Start-Up Installing Contractor Name
Start-Up Date
Condensate drain for furnace (if applicable)
Refrigerant piping complete and leak tested
Outdoor unit (volts AC) Overcurrent Protection Breaker / Fuses Amperes
"R" and "C" Outdoor unit control board (volts AC)
Heating Set-Up
Natural Gas LP Gas (Requires LP Conversion Kit)Electric Air Handler
LP Gas Conversion Kit Part # Used
LP Kit Installed By
Inlet Gas Pressure (in. w.c.")
Calculated input in btuh - clock the gas meter (Nat Gas Only)
Manifold Gas Pressure (in. w.c.")
Heating Type
Heat anticipator
recommended value
Electric Heat Kit Part # (if applicable) KW installed
Continued on next Page
Rated BTU/H (furnaces)
Print Form Reset Form