Filter
Top Products
36
Replacing the Light Bulb
WARNING:
Turn the power off before replacing the light
bulb.
The bulb could be HOT, wait until it has cooled
down before touching it.
To remove:
Remove the cap and setscrew.
Unhook the hook from the rear cover and remove the
faceplate.
q Cap
w Setscrew
e Rear cover
r Hook
t Face plate
Pull out the light bulb from the lamp socket.
y Light bulb
u Lamp socket
To replace:
Insert the bulb into the opening of the socket.
Attach the face plate inserting the ribs and hook into
the rear cover. Secure the face plate with the
setscrew, and attach the cap.
NOTE:
Replace the bulb with the same type rated 12V, 5W
(part number 000026002).
Correcting Distorted Stretch Patterns
The sewing results of the stretch patterns may vary
depending upon the sewing conditions, such as
sewing speed, type of the fabric, number of layers
etc.
Always test sew on a scrap piece of the fabric that
you wish to use.
If stretch stitch patterns are distorted, correct it with
the feed balancing dial.
q Feed balancing dial
w Neutral position
e Setting mark
Example: Pattern #34
(A): If the pattern is compressed, turn the feed
balancing dial in the direction of “+”.
(B): If the pattern is drawn out, turn the feed
balancing dial in the direction of “—”.
q
w
t
y
t
e
r
e
w
q
u
(A)
(B)
CARE AND MAINTENANCE