Filter
Top Products
6
5
4
3
2
1
1
2
3
6
3
5
4
GETTING READY TO SEW
Connecting the Power Supply
The Memory Craft 9700 is equipped with an auto
voltage system, which automatically adjusts the
equipment to any local power supply voltage between
100 and 240V, 50/60 Hz.
First, turn off the Power Switch. Then insert the Foot
Control Plug and Machine Plug into the Machine
Socket. Next, insert the Power Supply Plug into the
Wall Outlet and turn on the Power Switch.
1 Power Switch
2 Machine Plug
3 Machine Socket
4 Power Supply Plug
5 Wall Outlet
6 Foot Control Plug
NOTES:
Make sure to use the Power Supply Cord that came with
the machine.
If you turn off the power switch, wait for 5 seconds
before turning it on again.
The Foot Control cannot be used in the Embroidery
Mode.
For Your Safety:
While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the Power Switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the Foot Control.
Operating Instructions:
The symbol “O” of a switch indicates the “off” position
of a switch.
For appliances with a polarized plug (one blade wider
than the other):
To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If it
does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.