Intex Recreation Krystal Clear Filter Pump Water Pump User Manual


 
110
SAVE THESE INSTRUCTIONS
Page 8
(110) MODEL 634 FILTER PUMP ENGLISH 7.5” X 10.5” PANTONE 295U 01/31/2007
SSEETT--UUPP IINNSSTTRRUUCCTTIIOONNSS
FILTER PUMP HOSE CONNECTION SET UP
1. Remove the Krystal Clear™ filter pump and hoses from the packaging.
2. Place the filter pump in a location for hose (8) connections to the plunger valve
assemblies.
Note: Some regional regulations may require the filter pump to be
mounted on a stationary platform.There are two mounting holes located
in the pump base for this reason. Consult your local authorities for
filter-pump mounting requirements.
3. Grasp the two pump hoses (8) and connect the hose nuts to the filter pump.
4. In a counter-clockwise motion unscrew the threaded filter housing collar (1)
from the filter housing. Place it in a safe place.
5. The Filter Pump is an airtight system. In a counter-clockwise motion turn both
air release valves (2 & 7) 1 - 2 turns to open. DO NOT remove air release
valves as water will expel with force if the motor is turned on and injury
may occur.
6. Grasp and remove the filter housing cover (4). Check to see if a cartridge is
inside the housing. If yes, replace the cover, finger tighten the housing collar (1)
back onto the filter housing.
7. Gently finger tighten the sediment release valve located at the bottom of the
housing to be sure that water does not leak out.
8. When the pool is filled connect the hose from the bottom of the filter housing to
the highest strainer assembly. The hose connection is made at the bottom of
the plunger valve assembly. Use the hose nut to attach the hose.
9. Connect the 2nd hose to the middle of the motor housing and to the remaining
liner connection.
WARNING
Position this product away from pool to prevent a child from
climbing the pool.
WATER LEVEL
STRAINER
PLUNGER VALVE
ASSEMBLY
HOSE NUT
OUTLET HOSE
INSIDE
LINER WALL
STRAINER
FILTER HOUSING
COLLAR
FILTER CARTRIDGE
INSIDE
FILTER HOUSING
COVER
AIR RELEASE
VALVE
MOTOR
HOUSING
HOSE O-RING
POWER CORD
INLET HOSE
OUTSIDE
LINER WALL
(ILLUSTRATION NOT TO SCALE)
W
A
T
E
R
F
L
O
W
W
A
T
E
R
F
L
O
W