Filter
Top Products
page 6
10. Plug in vacuum cleaner. Turn ON/OFF switch to ON position.
NOTE: Switch will automatically return to the neutral position.
11. Start wet pick-up.
NOTE: To start the pumping feature, you will need approximately 4"
of water in the bottom of the tank. At that time you can start the
pump or continue with the standard wet pick-up until the tank has
reached capacity. The vacuum cleaner will automatically shut off
when full.
Removing Liquid from the Vacuum Cleaner Tank Using Pump
1. To empty a full tank by pumping, remove the vacuum hose from the
liquid. The ON/OFF switch must be manually held in the ON position
with the shut-off valve in the priming position.
NOTE: The vacuum hose must be attached to the vacuum cleaner in
order to prime.
NOTE: If the vacuum cleaner fails to prime, restrict airflow to the
vacuum by capping the end of hose.
2. Once the liquid begins to flow through the garden hose, the shut-off
valve should be turned to the full ON position to achieve the maxi-
mum flow. You will have to manually hold the ON/OFF switch in the
ON position for approximately 10-15 seconds. This will allow the
water level to reduce significantly. Pumping will continue automati-
6. Replace tank cover and secure with lid latches to the tank.
7. Connect a standard garden hose (not supplied) to the shut-off valve
(Fig. 6).
9. Attach the 1-1/4" vacuum hose to the tank inlet (Fig. 8).
WARNING!
To reduce the risk of electric shock, do not direct
discharge stream at vacuum cleaner.
Vacuuming Wet Materials Using Pump (Fig. 4 - 8)
1. Always unplug vacuum cleaner before removing the tank cover.
2. Remove the tank cover and dry pick-up filters. Tank should be cleaned
of any dirt or debris.
3. Make sure the foam sleeve is properly installed for wet vacuuming
(see “When Vacuuming Wet Materials”).
4. Insert the pump pick-up assembly's inlet fitting into the bottom of the
motor housing on the tank cover. Rotate until the discharge hose
lines up with the plug on the bottom of the tank cover (Fig. 4).
8. Before starting the pumping operation, check to see that the shut-off
valve is in the OFF position (Fig. 7).
Fig. 7
ON
PRIMED
OFF
Fig. 8
Fig. 6
5. Remove plug from discharge hole. Insert the discharge fitting and
rotate clockwise to lock into place (Fig. 5).
NOTE: Do not cut the security loop which fastens the plug to the lid
cage. The plug must be used for vacuuming dry materials.
Fig. 4
plug
discharge hose
inlet fitting
Fig. 5
discharge fitting
Starting and Stopping Vacuum Cleaner
1. To turn vacuum cleaner on, turn the ON/OFF switch to the ON
position.
2. To turn vacuum cleaner off, turn the ON/OFF switch to the OFF
position.
NOTE: Switch will automatically return to the neutral position.