Filter
Top Products
Lock
Washer
Hex Nut Deck Plate
Metal
Mounting Plate
UW/UWL
Tank
3/4" Screws (2)
Snap-Connect
Fitting (3 pieces)
Plastic Mounting Gasket
Equipment You May Need:
■■ For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this hot water faucet.
■■ Make sure that all electrical wiring and connections conform to local codes.
■■ A standard 120-volt grounded electrical outlet is required under the sink for the faucet’s electrical power.
■■ The wall outlet powering the tank must have electrical power supplied to it continuously.
■■ This outlet must be fused and should not be controlled by the same wall switch that operates a food
waste disposer, unless you have a SinkTop Switch
™
from InSinkErator
®
.
■■ If you suspect elevated levels of chlorine in your water, it is recommended to use our water
filtration system.
■■ The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa).
If it does, this will prevent your unit from operating properly.
■■ Moving parts inside the tank causing a rattling noise is normal.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Equipment Required:
■ Cordless Drill
■ Compression fitting,
T-fitting or saddle valve
■ Adjustable wrench
■ Phillips and flat blade screwdrivers
■ Pencil
■ Tape Measure
■ Level
■■ Anchors for drywall
■■ Hole saw
■■ Basin wrench
■■ Hole punch
If you intend to use the sprayer hole in your sink for your faucet, you may need a basin wrench and a
1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line.
See Step 1-B.
If you need to cut a mounting hole in your stainless steel sink, you may need a 1
1
⁄4" - 1
1
⁄2" hole saw made
for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other
than stainless steel.
WHAT YOU NEED TO GET STARTED
2
COMPONENTS IN THIS PACKAGE