Filter
Top Products
CCN 15250384
OPERATOR’S MANUAL PD05X-XXX-XXX-B
PE05X-XXX-XXX-B
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
RELEASED: 8-27-08
REVISED: 5-28-10
(REV. 0
7)
1/2" DIAPHRAGM PUMP
1:1 RATIO (METALLIC)
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
SERVICE KITS
Refer to Model Description Chart to match the pump material op-
tions.
637427-XX for uid section repair (see page 4).
637428 for air section repair (see pages 6 and 8).
PUMP DATA
Models . . . . . . . . . . . . . . . . . see Model Description Chart for “-XXX”
Pump Type . . . . . . . . . . . . . Metallic Air Operated Double Diaphragm
Material . . . . . . . . . . . . . . . . see Model Description Chart
Weight . . PX05A-XAS-XXX-B . . . . . . . . . . . . 10.36 lbs (4.70 kgs)
PX05A-XSS-XXX-B . . . . . . . . . . . . 16.57 lbs (7.52 kgs)
PX05R-XAS-XXX-B . . . . . . . . . . . . 8.04 lbs (3.65 kgs)
PX05R-XSS-XXX-B . . . . . . . . . . . . 14.25 lbs (6.46 kgs)
Maximum Air Inlet Pressure . . . . . . . . . . . 100 p.s.i.g. (6.9 bar)
Maximum Material Inlet Pressure . . . . . . 10 p.s.i.g. (0.69 bar)
Maximum Outlet Pressure . . . . . . . . . . . . . 100 p.s.i.g. (6.9 bar)
Air Consumption @ 40 p.s.i. . . . . . . . . . . . . . 1 c.f.m. / gallon (approx.)
Maximum Flow Rate ( ooded inlet) . . . 12.0 g.p.m. (45.4 l.p.m.)
Displacement / Cycle @ 100 p.s.i.g. . . . . 0.039 gal. (0.15 lit.)
Maximum Particle Size . . . . . . . . . . . . . . . . 3/32” dia. (2.4 mm)
Maximum Temperature Limits (diaphragm / ball / seat material)
E.P.R. / EPDM . . . . . . . . . . . . . . . . . . . -60° to 280° F (-51° to 138° C)
Hytrel® . . . . . . . . . . . . . . . . . . . . . . . . . -20° to 150° F (-29° to 66° C)
Nitrile . . . . . . . . . . . . . . . . . . . . . . . . . . 10° to 180° F (-12° to 82° C)
Polypropylene. . . . . . . . . . . . . . . . . . 35° to 175° F (2° to 79° C)
Polyurethane . . . . . . . . . . . . . . . . . . . 10° to 150° F (-12° to 66° C)
Santoprene® . . . . . . . . . . . . . . . . . . . -40° to 225° F (-40° to 107° C)
PTFE . . . . . . . . . . . . . . . . . . . . . . . . . . 40° to 225° F (4° to 107° C)
Viton® . . . . . . . . . . . . . . . . . . . . . . . . . . -40° to 350° F (-40° to 177° C)
Dimensional Data . . . . . . . . . . . . . . . . . . . . . . see pages 11 and 12
Noise Level @ 70 p.s.i., 60 c.p.m. . . . . . . . . . 75.0 db(A)
c
c
The pump sound pressure levels published here have been updated to
an Equivalent Continuous Sound Level (L
Aeq
) to meet the intent of ANSI
S1.13-1971, CAGI-PNEUROP S5.1 using four microphone locations.
NOTICE: All possible options are shown in the chart, however, certain
combinations may not be recommended, consult a representative or
the factory if you have questions concerning availability.
MODEL DESCRIPTION CHART
P X 05 X - X X S - X X X - B
Center Section Material
A - Aluminum
R - Polypropylene
Fluid Connection
A - 1/2 - 14 N.P.T.F. - 1
B - Rp 1/2 (1/2 - 14 BSP parallel)
Ball Material
A - Santoprene T - PTFE
C - Hytrel U - Polyurethane
G - Nitrile V - Viton
S - Stainless steel
Example: Model #PD05A-AAS-SAA-B
Fluid Section Service Kit # 637427-AA
PD05X - XXX - X X X - B
Ball Diaphragm
637427 - X X
Fluid Cap & Manifold Material
A - Aluminum
S - Stainless steel
Diaphragm Material
A - Santoprene T - PTFE / Santoprene
C - Hytrel U - Polyurethane
G - Nitrile V - Viton
Seat Material
F - Aluminum
P - Polypropylene
S - 316 Stainless steel
Hardware Material
S - Stainless steel
Electronic Interface
D - None
E - Available
Fluid Section Service Kit Selection
PD05R-XXX-XXX-B PD05A-XXX-XXX-B
Figure 1
INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET – BRYAN, OHIO 43506
(800) 495-0276 FAX(800) 892-6276
© 2010
www.ingersollrandproducts.com