Filter
Top Products
PD07P-X-X (en) Page 7 of 8
PARTS LIST / PD07P-X-X AIR MOTOR SECTION
)
134
138
139
135
107
171
121
166
201 (optional)129130
137
111
) TORQUE REQUIREMENTS (
NOTE: DO NOT OVERTIGHTEN FASTENERS.
(123) Torque to 4 - 6 in. lbs (0.45 - 0.68 Nm).
(134) Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm), wait 10 minutes, then
re-torque to 15 - 20 in. lbs (0.45 - 0.68 Nm).
LUBRICATION / SEALANTS
Apply Lubriplate FML-2 grease to all “O” rings, “U” cups and
mating parts.
Figure 4
232
637438 (optional)
137
136
144
103R
123
(
118 121 174
173
PILOT VALVE PARTS
200
141
101
129
140
132
168
169
118
144
174
)
123
103L
173
170
167
PILOT VALVE PARTS
MAJOR VALVE
MAJOR VALVE DISASSEMBLY
Unthread (134) bolts, releasing (129) mu er assembly.
Pull (135) valve block and components from (101) center
body.
Remove (132) gasket, (141) valve plate and (140) valve
insert from (135) valve block.
Remove (134) bolts, releasing (107 and 136) plugs and
(111) spool.
1.
2.
3.
4
.
MAJOR VALVE REASSEMBLY
Assemble new (138 and 139) “U” cups on (111) spool -
LIPS MUST FACE EACH OTHER.
Assemble (137) “O” rings to (136) large plug.
Assemble (137 and 166) “O” rings to (107) small plug.
Insert (111) spool into (136) large plug, then insert (136)
large plug into (135) valve block, being sure the (111)
spool is rotated to accept (140) valve insert.
Assemble (107) small plug into (135) valve block.
Assemble (140) valve insert and (141) valve plate to
(135) valve block. NOTE: Assemble (140) valve insert with
“dished” side toward (141) valve plate. Assemble (141)
valve plate with identi cation dot toward (132) gasket.
Assemble (132 and 200) gaskets, (135) valve block and
(129) muffler assembly to (101) center body, securing
with (134) bolts. NOTE: Tighten (134) bolts to 15 - 20 in.
lbs (1.7 - 2.3 Nm).
1.
2.
3.
4.
5.
6.
7.