Filter
Top Products
UH68 ODK/ODH Tent Heater
2-6
7. Uncoil remote control (2) inside tent and feed through the collar with the return duct(5).
Attach remote control (2) to heater. Make main sure switch is in the off position.
8. Attach power cable (3) to heater then plug in to power supply. The green, main power LED,
on the remote panel should illuminate.
9. Check fuel in can(14), fill if necessary with authorized fuel (see section one). Attach Suction
Feed Adapter(15) and open vent(16).
10. Attach fuel supply line(17) to Suction Feed Adapter(15). Make sure drain cock(18) on
supply line(17) is closed. Attach supply line(17) to heater QD fitting(19). Move the fuel
can(14) as far away from the heater as possible without pulling the fuel supply line(17)
taught.
11. Attach overflow line(20)
NOTE!
Open end of overflow hose should discharge to a safe, outside location along a
downslope and below the level of the heater. A piece of commercial petroleum
absorbent material (21), will be placed under the end of the overflow hose to catch any
fuel that may spill.
12. Attach exhaust stack cap(22) to stack(23). Slide exhaust stack(22) through stack holder(24)
on side of PUDA and over exhaust elbow. Push down on stack holder(24) to stabilize stack.
2 3