Filter
Top Products
43533-01 05/28/2008
6
43533-01 05/28/2008
7
INSTALLATION
Figure 5 - Attach Hanger to Electrical Box
INSTALLATION continued
1) If you are replacing an existing light fixture, disconnect and remove the old fixture and
hanger bracket, leaving the exposed wires coming from the electrical box.
2) Attach the Hanger Bracket assembly to the electrical box as shown in Figure 5.
4) Use UL-approved wire connectors to connect the wires, black-to-black, white-to-white. Loop
the ground wires around the Ground Screw, then tighten the Ground Screw. See Figure 7.
3) Suspend the fixture by placing the Cable Loop over the Cable Loop Hanger. See Figure 6.
Figure 6 - Suspend the Fixture
Cable Loop
Cable Loop Hanger
Ground Screw
Figure 7 - Ground Screw
Hanger Bracket
Electrical Box