Filter
Top Products
7
Figure 5
81605-01 R20140819
Figure 6
Timer Function (Figure 5)
The timer function may be activated when the heater display is
in any function. This function allows you to set the length of time
the heater will run before turning itself off, from 0 hour to 8 hours.
" 0 " means there is no set running time and heater will run
continuously. Pressing the Timer Button will increase the
length of time by 1 hour each time when this button is pressed.
After the display has shown " -8 ", pressing the Timer Button
one more time will reset the heater to run continuously. The heater
will turn off when the set time has elapsed. The unit can be turned
back on by pressing the Power Button .
TIP-OVER SWITCH
This heater is equipped with a safety tip-over switch, which is
located on the bottom of the heater. This feature cuts the main
power to the heater if it gets knocked over. If the heater does tip
over, simply stand it upright in order to resume operation.
THERMAL PROTECTION SYSTEM
This heater includes an Overheat Protection System that shuts the
unit off when the unit reaches excessively high temperature. If this
occurs, the heater can only resume its normal operation after
resetting it. To reset the heater:
1. Unplug the heater and wait 10 minutes for the unit to cool down.
2. After the 10 minutes, plug the unit in again and operate normally.
Handheld Remote Control (Figure 6)
Your remote control unit uses one (1) "CR 2025" button cell
(included) for operation. To replace the button cell, simply open
the battery cover at the back of the handheld remote control unit.
Insert a new button cell and then replace the cover.
Battery Disposal - Please dispose of the used battery per
municipal or provincial law.
Automatic Temperature Control
1. To set the room at a specific temperature, press the or
buttons to the desired temperature. The heater is now in Auto
Temperature Mode .
2. The set temperature will show for several seconds and then the
display will return to indicate the current room temperature .
NOTE: The temperature display does not indicate the temperature
of the heated air being delivered by the heater.
3. When the room temperature reaches 2 degrees above the set
temperature, the heater will shut off. When the room temperature
reaches 2 degrees below the set temperature, the heater will turn
back on and continue to cycle off and on to maintain the set
temperature.
NOTE: It is normal for the fan to run for serval minutes when the
heater shuts off after reaching the set temperature.