Filter
Top Products
6
PARTS OF THE HEATER
Parts of the Heater
1.
2. Safety Grille
3. Castors
4. Remote Control
5. Remote Control Sensor
6. Washable Air Filter
Control Panel
Symbols
OPERATING INSTRUCTIONS
1. Place the heater on a firm and level surface.
2. Plug the cord set into a 120 volt AC outlet. Be sure that the
plug fits tightly into outlet. When plugs fit loosely into
receptacles, they may slip partially or completely out of the
receptacle with only the slight movement of the attached cord.
Receptacles in this condition may overheat and pose a serious
fire hazard; if covered by a curtain or drape, the fire hazard is
even greater.
3. When the heater is initially plugged in, there will be a "beep”
sound and Power Light will come on indicating that there is
power to the unit. The Power Light will remain on until the
heater is unplugged from the electrical outlet. (Figure 4)
NOTE: Please always keep the control panel cover open to see
Power Light when turn on the heater.
4. Turn the heater ON by pressing the Power Button .
5. Press the button to change the display to show the
temperature reading in Celsius. Press the button again to
change the display back to show the temperature reading in
Fahrenheit.
6. Upon turning the heater on, the unit will be in HIGH heat.
7. Press the button to switch over LOW or HIGH heat.
(Figure 4)
Power Button
H/L Heat Button
°C/°F Temperature Button
High Temperature Setting Button
Low Temperature Setting Button
Timer Button
Figure 4
Operation
(Figure 3)
81605-01 R20140819
Figure 3
5
3
1
4
2
6
8. To turn the heater OFF, press the Power Button again.
The unit will first turn off the heating elements, the fan will be
shut down a few minutes later. Unplug the unit by pulling the plug
from the electrical outlet only after the fan has stopped.