Filter
Top Products
41479-01 01/06/2005 5
OPERATION
FIGURE 3
This appliance is for household
use only.
1. Place the fan on a dry, safe, flat
surface where it cannot fall or be
pulled by the cord.
2. Plug the fan into a grounded
120-volt AC electrical outlet (or-
dinary household current).
DO NOT use any other type of
outlet. Make sure that the rated
voltage of the fan is the same as
the power source before plug-
ging it into the power source.
3. Turn the fan “ON” or “OFF” by
sliding the Power/Speed Control
to the right or left. The power
should always be OFF before un-
plugging the fan.
4. To select the speed, move the
Power/Speed Control from
OFF to the desired speed set-
ting: O (off), I (low), II (me-
dium), III (High).
5. To control the upward and
downward direction of airflow,
loosen the screw on the side of
the fan housing neck. Adjust
to the desired angle and
tighten the screw.
6. To make the fan oscillate, push
the oscillation knob down. To
stop oscillating, pull the oscilla-
tion knob up. The oscillation
knob is located on the top of the
fan housing, near the handle.
Handle
Oscillation
Knob
Motor
Housing
Up/Down
Adjustment
Screw
Base
Power/Speed
Control Switch
41479-01 Rev 01-06-05.pmd 1/6/05, 5:06 PM5