Filter
Top Products
42804-01 05/31/2006 5
ENGLISH
OPERATION
1. Place the fan on a dry, safe, flat
surface where it cannot fall or be
pulled by the cord.
2. Plug the fan into a 230-volt
AC electrical outlet (ordinary
household current). DO NOT use
any other type of outlet. Make
sure that the rated voltage of the
fan is the same as the power
source before plugging it into the
power source.
3. Turn the fan “ON” by turning the
Power/Speed Control Switch
to “I” (low), “II” (medium), “III”
(High). Turn the fan “OFF” by
turning the Power/Speed Control
Switch to “O”. See Figure 3. The
Power/Speed Control Switch
should always be OFF before
unplugging the fan.
4. To control the upward and
downward direction of airflow,
loosen the Up/Down Adjustment
Screw screw on the side of the
fan housing neck. See Figure 3.
Adjust to the desired angle and
tighten the screw.