Hunter Fan 90442 Fan User Manual


 
5
44096-01 20130220 ©2013 Hunter Fan Co.
FUSED PLUG
This plug is a safety feature. It contains a safety
device (fuse) that should not be removed. Discard
product if the attachment plug is damaged. To
reduce the risk of re, electric shock and personal
injury, DO NOT remove, replace, repair or tamper
with the originally supplied plug. If the Fan does
not function properly, it may be due to the safety
device incorporated in this plug.
If the fuse fails, it is generally due to a short circuit
or circuit overload. Replace the fuse as per the
instructions below. If the replacement fuse fails,
immediately unplug the unit and contact our
technical support department for assistance.
Fuse Replacement:
1. To replace the fuse, rst turn the unit it off and
unplug it from the wall. Locate the door on top
of the plug. Figure 1.
2. Slide the door on top of the plug towards the
blades. Figure 2.
3. Carefully remove the fuse from the clips holding
it on the top and bottom. Figure 3.
Warning! Electrical Hazard! Only replace
with a fuse type and rating matching what was
removed from the product. If the product fails a
second time, immediately unplug it and contact our
technical support at 1-888-830-1326.
4. Gently push the fuse back into the pins that will
hold it in place.
Note: If the fuse is not seated properly, the unit
will not function.
5. Slide the Door back over the fuse box in the plug.
6. Plug the fan back in and resume use.
Figure 1.
Figure 2.
Figure 3.