Filter
Top Products
10
Figure 17
Figure 16
Figure 18
GRILL ASSEMBLY (CONT.)
Front Grill
Hunter Logo
Grill
Ring
Screw
Screw
Back Grill
Figure 19
Cord Clip
Cord
Notch
6. Remove the grill ring from the front grill by loosening
the screw holding it.
7. Place the front grill against the back grill so that the
Hunter logo faces right side up and push together until
the tabs on the grills hold them together. Figure 16.
8. Expand the grill ring by loosening the screw that
secures it. Figure 17.
9. Slide the grill ring over both front and back grills
turning the ring so that the screw that secures it, is
on the bottom. Figure 17.
10. Tighten the screw to secure the grill ring over both
the front and back grill. Figure 18.
11. Straighten the cord from the motor housing along
the telescoping pole and snap the cord clip over the
cord onto the pole so that the cord rests in the notch
on the clip. Figure 19.