Filter
Top Products
42936-01 10/17/2007
9
B10
Install the wiring and the strain relief into the wiring
access hole you made earlier.
B11
Connect 4” duct and vent to the outside. Use duct tape to
secure joints. If ducting does not fit securely, an adapter
may need to be purchased.
Go to
Section E -
Final Installation
on page 14.
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new fan
housing. The opening needs to be 11” x 9 5/8”.
Section C - Existing Construction – accessible from above
NO EXISTING FAN
OR