Filter
Top Products
13
45049-01 • 07/13/09 • Hunter Fan Company
7-11.
To connect the wires, hold the bare metal leads together and
place a wire connector over them, then twist clockwise until tight.
Connect the black wire with a white stripe from the lower switch
housing to the black wire from the light kit. Connect the white wire
from the lower switch housing to the white wire from the light kit/
speaker. Secure all wire connections using wire connectors.
7-12. To attach the lower switch housing assembly to the fan, partially
install two housing assembly screws into the upper switch
housing.
7-13. Connect the upper plug connector from the motor to the lower
plug connector in the lower switch housing assembly.
Note: Both plug connectors are polarized and will only t together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
7-14. Align the notches in the sides of the lower switch housing with
the screws on the upper switch housing. Twist the lower switch
housing and the light kit/speaker assembly clockwise to lock the
screws in place.
7-15. Install the third housing assembly screw.
7-16. Tighten all three screws securely.
7 • Light/Speaker Assembly Installation (Continued)
Housing
Assembly Screw
Step 7-11
Wire
Connections
Lower Switch
Housing
Upper
Switch
Housing
Housing
Assembly
Screw
Notch
Steps 7-12 – 7-15
Steps 7-14 – 7-16