Filter
Top Products
9©2010 Hunter Fan Co. 44028-01 20100119
Figure 13.
5. Lift the UVC Bulb Carrier out of the unit. Figure 12.
6. Unscrew the UVC Bulb From the carrier and dispose
of the UVC bulb in accordance with local or State
guidelines as trace amounts of Mercury are present.
7. Partially remove the new UVC Bulb from it’s packaging
being careful not to let the bulb come in contact with
your skin.
Note: Oils from your skin can cause damage to the bulb
and will prevent it from working.
8. Using the bag the bulb came in to prevent skin contact
with the bulb, screw the bulb into the Carrier socket.
Figure 13. Do not over tighten. Discard the bag.
9. Reinsert the Bulb carrier into the unit at a 45
o
angle
and turn clockwise to lock into the Air Purifier.
Note: If the UVC Bulb door is not re-installed correctly,
the unit will not run.
10. Reattach the UVC cover by inserting the back tabs
into the Air Purifier and snapping the tab back into
place. Figure 14.
11. Reinsert the 2 screws securing the UVC Cover into
place. Refer to Figure 9.
Figure 14.
Tabs
Clean the Unit
Clean the outside of the unit with a soft, damp cloth.
The rear grill can be cleaned in soapy water after it has
been removed from the unit and the pre-filter has been
removed.
NOTE: Ensure the grill is completely dry before
reinstalling it on the unit. Failure to do so could cause
damage to the filters or motor.
Figure 12.