Filter
Top Products
8©2010 Hunter Fan Co. 44028-01 20100119
Figure 9.
Replace The UVC Bulb
The UVC light should be replaced once yearly. Follow
these instructions to remove and replace the UVC bulb.
1. Unplug the unit from the wall outlet and turn it over, so
the bottom of the unit is visible.
2. Using a small phillips screwdriver remove the 2 screws
holding the UVC Cover in place. Figure 9.
3. Gently push the tab on the UVC Cover and lift it away.
Figures 9. and 10.
4. Locate the UVC Bulb Carrier and turn it 45
o
counter-
clockwise. Figure 11.
Figure 10.
Figure 11.
Tab
Screws
5. If the Pre-Filter needs to be cleaned, It may be
submerged in warm soapy water to clean. Gently lift
and submerge the filter several times to clean.
6. When complete, rinse the filter with warm water and
allow to dry completely.
Note: Wet parts placed into the unit can cause damage
to the filters and or the motor of the Air Purifier.
Check or Replace Your Filter
1. Turn the Air Purifier off and disconnect from the wall.
2. Remove the rear grill on the back of the unit by
pressing the tab at the top of the unit, under the
handle and pull the rear grill outward. Figure 7.
3. Remove the HEPA Filter from the unit.
4. Check the Filter for particle build-up.
5. The HEPA filter should be removed every 12 months
of use and matched to the color indicator on the inside
of the filter compartment. When the filter matches the
dark, charcoal gray indicator, it should be replaced.