11
42786-01 • 08/14/09 • Hunter Fan Company
ATTACHING THE UPPER SWITCH HOUSING
7-5. Locate the switch housing mounting screws in the sack parts.
7-6. Insert and tighten the screws into the outermost holes in the upper
switch housing.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all four housing assembly screws could result in
water entry into live connection area and/or the switch housing
and light xture falling.
ATTACHING THE LOWER SWITCH HOUSING/LIGHT
ASSEMBLY
7-7. Locate the housing screws.
NOTE: Depending upon your fan model, these screws may be
installed in the four spokes from the switch housing mounting plate,
or they may be located in the sack parts.
7-8. Partially install the screws into the spokes from the switch housing
mounting plate.
NOTE: if these screws came installed, make sure that they are
partially installed in order to complete the following steps.
7-9. Connect the upper plug connector to the lower plug connector
from the lower switch housing assembly.
NOTE: Both plug connectors are polarized and will only t together
one way. Make sure that both connectors are properly aligned
before connecting them together. Incorrect connection could cause
improper operation and damage to the product.
7-10. Align the keyhole slots in the lower switch housing with the housing
assembly screws that were installed in Step 7-8.
7-11. Turn the lower switch housing clockwise until the housing assembly
screws are rmly situated in the narrow end of the keyhole slots.
7-12. Tighten all housing assembly screws.
7 • Completing Your Installation With a Bowl Light Fixture (Continued)
Step 7-5
Step 7-7
Switch
Housing
Mounting
Screws
Housing
Screws
Spokes