10
42687-01 • 08/03/09 • Hunter Fan Company
Steps 7-1 – 7-3
Housing
Assembly
Screw
7 • Completing Your Installation With or Without a Light Fixture
Upper
Switch
Housing
7-1. To attach the upper switch housing, partially install two #6-32 x
3/8” housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are rmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8” screw into the housing. Tighten
all three screws rmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light xture falling.
Your Hunter fan comes with an integrated light xture assembly and an
optional switch housing cap and plug button. is feature gives you the
option of installing the fan with OR without the included light xture.
If you want to install the light xture, proceed with step 7-5 now.
If you do not want to install the light xture, you need to uninstall it
now. See “Uninstalling the Light Fixture” on page 12.
WARNING: Use only the light xture supplied with this fan model.
Note: In compliance with US federal energy regulations this
ceiling fan contains a device that restricts the light kit to a
maximum of 190 Watts. Exceeding that limit or the marked
limit on this product may result in re hazard or improper
operation.
