5
41897-01 • 11/22/05 Hunter Fan Company
2 • Assembling the Fan for Ceilings 8-10 Feet High
Step 2-2
Upper Clamp
Assembly Screw
Step 2-1
To install the fan on ceilings 8-10 feet high, follow the steps in this
section. (Skip to the next section if you are installing the fan on a
ceiling 10 feet or higher.)
2-1. Remove the two assembly screws in the upper clamp.
2-2. Insert the downrod through the canopy, canopy trim ring, and
spindle. Feed the wires from the fan through the downrod.
2-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads will still be visible; this is normal.
Securely retighten the set screw with a wrench or pliers.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
CAUTION: Do not carry or lift fan by the canopy.
2-4. Lower the spindle onto the lower clamp.
2-5. Reassemble the upper clamp around the pipe using the two
assembly screws removed in Step 2-1. Lower the clamp onto the
spindle. Tighten the set screws using the provided allen wrench.
ATTENTION: Do not overtighten the set screws; doing so will
damage the wrench.
2-6. Go to 4 • Installing the Ceiling Plate on page 7 to continue the
installation.
Canopy
Spindle
Canopy
Trim Ring
Set Screw
Steps 2-4 – 2-5
Set Screw
Upper Clamp
Spindle
