Filter
Top Products
©2008 Hunter Fan Co. 43002 Rev 04-29
3
Power: Turns the humidifier on and off. the power should
always be off before unplugging the humidifier, moving the
humdifier, or refilling the water tank.
Refill Light: The red LED turns on to signal that the humidifier
has automatically turned off and the Water Tank needs to be
refilled.
Humidity: Enables you to set the desired maximum humidity
level. Once this level is reached, the unit will automatically shut
off until the humidity level drops. NOTE: The humidifier may not
be running because the Span Setting may need to be adjusted.
Speed: Sets the humdifier’s fan speed to Low (1), Medium (2),
or High (3).
Timer: Sets the humidifier to run for 2, 4, 8, or 10 hours.
when the timer is not used, the humidifier will run and cycle
automatically.
Control Panel
Power
Timer
Humidity
NiteGlo™
Refill Tank
LED (Red)
Speed
LED Display
Figure 2
Using Your Humidifier
1. Remove the Hunter® Evaporative Humidifier from its
packaging.
2. Place the humidifier on a hard, flat, water resistant surface.
Always place the humidifier at least six (6) inches away from
walls and sources of heat.
3. Grasp the Water Tank by its Tank Tote and remove it from
the Tray. See Figure 3.
4. Turn the Water Tank upside-down and remove the Water
Tank Cap. See Figure 4.
Basic Set-Up and Operation
Twist to open
Figure 4
Water Tank Cap
(under Tank)
Figure 3
Tank Tote
5. Fill the Water Tank with water, return the Water Tank Cap to
its position and tighten it, and return the Water Tank to the
Tray.
6. Plug the humidifier’s Power Cord into a standard household
power outlet.
7. Press the Power Button on the Control Panel.
8. To see the current humidity, press the Humidity button. To
change the humidity, press and hold the Humidity button for
3 seconds. The LED Display will flash the current humidity
setting. Press the Humidity button until the LED Display
shows your desired humidity setting. You can change the
setting in 5% increments from 30% relative humidity to 80%.
When the LED Dispaly shows your desired humidity setting,
release the Humidity button. After 2 seconds, the humidity
setting is set and the LED Display will show the relative
humidity.
9. To see the current Fan speed setting, press the Speed
button. To change the Fan speed setting, press and hold the
Speed button for 3 seconds. The LED Display will flash the