Filter
Top Products
©2010 Hunter Fan Co. 43057-01 20100609
4
OPERATION
To turn your SOLO
2
unit on, press the up and down touch
pads on the unit simultaniously. Once on, press the up or
down arrow buttons to adjust fan speed. To turn your SOLO
2
unit back off, press both touch pads on the front of the unit
again. Figure 3. There are ten fan speeds on your Solo
2
unit. Once set, your SOLO
2
unit will remember your last
setting when it is turned back on.
NOTE: When using the touch panel on the front of the
SOLO
2
, you must use your fingertips to operate the controls.
Finger nails, pens, pencils, etc will not work to activate or
control the unit.
AIR CLEANER MAINTENANCE
Proper maintenance of your Hunter Air Cleaner will help
ensure years of trouble free service. Follow these steps to
properly maintain your air purifier:
1. Approximately every 90 days, the outside of the unit
should be cleaned with a soft, damp cloth.
2. Follow the instructions for Changing the Filter on this
page to determine how to replace the filter. The Hunter
Logo on the front of the SOLO
2
will flash amber when
it is time to change the filter.
NOTES:
• The air cleaner must be unplugged from the power outlet
during the cleaning process.
• Be sure the unit is completely dry before plugging in and
using.
• Never immerse unit in water or use harsh chemicals to
clean.
Cleaning
Figure 3.
Touch
Sensitive
Areas
ADJUSTING THE SOLO
2
Now that the SOLO
2
is functional, you will need to adjust
it to direct the air flow towards you. Holding the top of the
SOLO
2
, tilt the unit back or forth until you find the angle that
will provide the best comfort level. Figure 4.
Figure 4.