Filter
Top Products
41695-01 5/17/2004
INSTALLATION INSTRUCTIONS FOR HUNTER
DUAL MOUNT LIGHT FIXTURES
MODEL 28393, 28394
NOTE: This is a Dual Purpose Light kit that allows the user to install the light fixture to the ceiling, as you would any
light fixture. It also has the feature of being convertible to mount directly to a Hunter ceiling fan. Please follow the
directions below that pertain to the type of installation this light fixture will be installed in.
IMPORTANT NOTE: READ AND SAVE THESE INSTRUCTIONS!
WARNING
• To avoid possible electrical shock, before in-
stalling light fixtures, disconnect power by
turning off the circuit breakers both to the
outlet box and to its associated wall switch
location. If you cannot lock the circuit break-
ers in the off position, securely fasten a
prominent warning device, such as a tag, to
the service panel.
• This fixture must be mounted to an approved
outlet box that is directly supported by the
building structure.
• All wiring must be in accordance with na-
tional and local electrical codes and ANSI/
NFPA 70. If you are unfamiliar with wiring,
you should use a qualified electrician.
CAUTIONS
• Read entire text carefully before beginning
installation and save these instructions.
• Should you desire to change the unit over to
a different style mounting, you will need to
follow these instructions to convert from one
installation style to another.
CEILING LIGHT FIXTURE
SECTION:
STEP 1: Site Pr eparation - Ceiling Light
1. If you are replacing an existing light fixture,
disconnect and remove the old fixture and mounting
bracket, leaving the wires exposed coming from the
outlet box.
2. Locate and thread the two 8-32” screws, sup-
plied in the sack parts, into the hanger bracket threaded
holes as shown in Figure 1.
3. Locate and install the two 8-32” nuts on the 8-
32” screws and tighten until snug against the hanger
bracket.
4. Using the two screws supplied with the outlet
box, mount the hanger bracket to the outlet box, as
shown in Figure 2.
Warning: Failure to ensure that all fasteners
are secure could result in the fixture falling.
8-32” SCREWS
HANGER
BRACKET
8-32”
NUTS
TOWARDS
ELECTRICAL
BOX
FIGURE 1
HANGER
BRACKET
HOUSE
SUPPLY
LEADWIRES
ELECTRICAL
BOX
SUPPLY
GROUND
WIRE
GROUND
SCREW
ELECTRICAL
BOX
MOUNTING
SCREWS
LIGHT
FIXTURE
GROUND
WIRE
FIGURE 2