Filter
Top Products
Place smaller diameter end of wand,
into bottom of rack. Snap wand into
clip at the top. Repeat with other
wand.
STEP II Attach hose
1-5
1-8
1-9
1-6
1-7
Align end of hose with projection (E)
over slots (F) in dirt duct on back of
handle.
Slide hose into (F) and twist hose to
lock it into place.
Position hose over rack and into
hose tube (G).
Open tool cover.
Insert ends of dusting brush (H),
crevice tool (I) and furniture nozzle
(J) into storage areas.
Close tool cover.
NOTE: Hose must be connected as shown for all
operations.
STEP III Position tools
H
I
J
E
F
F
G
4
TM
Now that your new
Self-Propelled
WindTunnel
vacuum cleaner is
assembled,
it’s ready to use!
STEP I Attach handle
Looking at the back of the cleaner,
make sure switch (A) is in the OFF
position.
Slide handle into back of cleaner.
Push screws into holes on back of
handle.
Using a Phillips screw driver, tighten
screws securely.
1-2
1-3
A
1 - 4
B
C
D
Remove switch lock (B) above ON-
OFF switch (C) on front of handle by
pulling it straight out. Dispose of
lock.
If switch lock has come off during
assembly, make sure switch is in
OFF position (down) before plug-
ging cord into electrical outlet.
Remove label (D) from self-propel
button.