Filter
Top Products
Replacing final filter
The final filter assists in the filtration
process to return clean air to the room.
The pleated filter will become dirty and
needs to be replaced about once a year
to maintain efficient filtration. The 3 layer
filter (some models) can be washed in
the same manner as the secondary filter
and reused.
To remove final filter, first open the door
on the side of the cleaner (Fig. 3-5).
Grasp filter (B) and pull it straight out.
Reposition new filter by reversing this
procedure.
The final filter can be replaced with any
of the following filters.
3 layer, washable - HOOVER part No.
40110006
HEPA filter HOOVER part No. 43613022
Do not operate cleaner without both
the secondary and final filter in place.
Cleaning secondary
filter
Disconnect cleaner from electrical
outlet.
The secondary filter (A), located
behind the grill in the bottom of bag
compartment, protects the motor from
dirt particles.
If filter becomes dirty, pull off grill and lift
out filter.
Hand wash filter in cold water with mild
detergent, then air dry.
Reposition dry filter and grill.
Should you want to replace this filter,
ask for HOOVER part No. 38765019.
9
3-1
3-4 3-5
Secondary and final filters
3-2
3-3
A
B
C
A
B
Changing filter bag
Disconnect cleaner from electrical
outlet.
Where to buy
Filter bags may be purchased from
Authorized Hoover Dealers (Depot),
Leading Retailers, from Hoover Factory
Service Centers, or through The Hoover
Company on-line at www.hoover.com.
What to buy
To assure cleaning effectiveness, use
only Genuine HOOVER® Allergen
Filtration T
ype Y disposable filter
bags.
Continued
Replacing bag door
Reposition bag door by placing tab on
bottom of door into opening (C).
Press top of door to snap securely shut.
®
®
It is imperative that you use only gen-
uine HOOVER filter bags made by The
Hoover Company to assure your clean-
er operates at peak performance.
HOOVER bags can be identified by
these trademarks —
Removing bag door
To change filter bag, grasp top of bag
door and pull door forward.
Remove door.
Removing and installing filter
bag
Grasp filter bag collar (A) and pull collar
from tube (B).
Note: Do not clean out old filter bag and
reuse. Discard used filter bag.
Hold new filter bag as shown. Align open-
ing in filter bag with (B).
Push (A) firmly onto (B).
Tuck in filter bag.