Filter
Top Products
Remove agitator and used belt.
Discard used belt.
Pull old bulb straight out of
socket. Push new bulb straight
into socket until locked into place.
Excessive force is not required.
Reposition the lens and secure
with the two screws.
What to buy
This cleaner uses a 12 volt, wedge
base type 912 bulb, Hoover part
No. 27313-101.
How to replace
Disconnect cleaner from electrical
outlet.
Using a screwdriver, remove
the two screws as shown and
lift off lens.
9
The headlight
3 8
3 8
3 9
3 9
4 1
4 2
4 2
4 0
4 0
The belt
The belt on your HOOVER cleaner
causes the agitator to rotate and is
i m p o r tant for the effective operation of
the cleaner. The belt is located under
the bottom plate of the cleaner and
should be checked from time to time
to be sure it is in good condition.
When to replace
To check belt, remove bottom plate
and hood as shown in “How to
replace belt.” Replace belt if it is
stretched, cut or broken.
What to buy
To assure effective operation, use
only genuine HOOVER belts with
your cleaner. When purchasing a
new belt, ask for Hoover part
No. 38528-033.
How to replace
Disconnect cleaner from electrical
outlet.
Place handle in low position and
turn cleaner over so bottom side is
up.
Remove the 4 screws as shown
with a Phillips head screw driver.
Lift off bottom plate (A).
4 1
A
Continued