Hoover 53425 Vacuum Cleaner User Manual


 
B. Join upper and lower handles
Join upper and lower handles, aligning
holes.
Place cord clip around cord with flat
side toward handle of cleaner and
holes to the front.
Insert bolt through washer, cord clip
and both parts of the handle (small
holes). Secure with nut. Pull up slack
in cord and tighten nut with screw-
driver.
C. Attach cloth bag to cleaner
The cloth bag is connected at the
rear of the cleaner. There are two
projections at the bottom of the
cloth bag assembly.
To attach cloth bag to the cleaner,
place the two projections at the bot-
tom of the cloth bag assembly inside
the metal grooved plate. (You will
find the grooved plate extending out
from the bottom of the cleaner.IFig.1.
Just above the opening at the rear of
the cleaner is the bag clip. Pull the
bag clip to the left and fit bag against
opening. When you release the bag
clip, it should move to the right and
fit completely over the bag lock. Fig.2.
Attach the bag to the bag spring hook,
which is located on the top section
of the handle. Fig. 3.
HOW TO USE YOUR CLEANER
How to operate
Operate cleaner only at voltage speci-
fied on data plate on bottom of cleaner.
Warning: Electric shock could occur if
I
used outdoors or on wet surfaces.
On-off switch
The ON-OFF switch is located on the
handle bail. To turn the cleaner on
and off, push button on cleaner han-
dle bail with toe.
4