Filter
Top Products
Replacing
brush
roll
Removing brush
roll
Slide
Brush
Roll
Control
(Fig.
2-9)
to
"Hard"
(0FF)
position.
Turn cleaner over
and
remove bottom
plate
(Fig.
3-e).
Lift
up brush
roll
and slide
V-belt
(D)
off brush
roll.
Inspecting V-belt
The V-belt
is
designed to
last for a long
time
and
is not
normally replaced. However, if
V-belt
is
cracked,
gouged
or broken,
now is a
good
tinre to
replace it as follows.
Slide
flat
belt
off
large
pulley
as shown
in
Fig.
3-
10.
To remove V-belt, slide back of
belt over
pul-
ley
(C).
Then firmly
pullon
belt and
"snap"
it
out.
Discard used belt.
Replace
with
HOOVER
part
No. 38528034.
To install
new
belt
(with
lettering
on outside
of belt), slide back
of belt over
pulley
and
pull
front
of belt toward
groove
(E)
next
to
pulley.
Belt will
"pop"
into
place.
Positioning belt
on brush
roll
Before
positioning
belt onto brush roll,
check
for
debris
accumulation as
described
in Fig.
4-2.
lnsert brush
roll
through belt and
position
belt
in
groove
(F)
on
brush
roll.
Installing brush
roll
Grasp brush
roll
and
fit
it
into
position
by
first
sliding end,
opposite the belt,
into
the
rectangular
slot
(G)
on side of
cleaner.
Push
other
side of
brush
roll
(H)
into
place.
Belt
may fit
loosely
when
prop-
erly
installed.
Reposition
flat
belt
and bottom
plate
(Fiqs.
3-12
and
3-13).
Powered hand tool
Agitator brush
roll
replacement
When agitator
brush
roll
brushes
are wonr, the bruslt
roll
should
be
replaced. Ask for
HOOVER
part
No.
4841 4088.
How to replace
l. Remove
tool
from
hose
and turn
it
so
bottom
faces
up.
Press
the
latches
on
either side of tool
and
remove
bottom
plate
(A).
2.
Unscrew
the two
Phillips
screws and
remove
belt
guard
tB).
>z\\X\
a\\