Filter
Top Products
10
3-29
3. Remove agitator including end plates
(C) and discard.
4. Inspect belt to ensure that it is in
good condition. If belt is cracked,
gouged or broken, replace it (see follow-
ing section).
5. Insert brush roll through belt and posi-
tion belt over gear teeth (D) on brush
roll.
C
D
3-27
A
Powered hand tool
Agitator brush roll
replacement
When agitator brushes are worn, the
brush roll should be replaced. Ask for
HOOVER part No. 48414088.
How to replace
1. Remove tool from hose and turn it so
bottom faces up. Press the latches on
either side of tool and remove bottom
plate (A).
3-28
2. Unscrew the two Phillips screws and
remove belt guard (B).
B
3-23 3-24
3-25
Hold new agitator (B) in one hand, and
the belt (C) in the other. Slide the belt
onto the agitator, until belt is in the mid-
dle of the agitator. Align the belt directly
over the grooves on the agitator.
Slide end plates (E) of the agitator into
the slots (F) on both sides of the agitator
cavity.
Turn agitator to make sure it rotates
freely.
Replace bottom plate and screws (7).
B
E
F
C
Belt replacement
The belt on your Hoover cleaner causes
the brush roll to rotate and is important
for the effective operation of your
cleaner. The brush roll belt is designed
to last a long time and does not normally
need replacement. The belt is located
under the hood of the cleaner and
should be checked from time to time to
be sure it is in good condition.
3-26
A
Inspecting the belt
Disconnect cleaner from electrical
outlet.
The belt can be seen by removing the
bottom plate (A). To remove, step on
handle release pedal and place cleaner
in the lowest position. Turn cleaner over.
Using a Phillips screwdriver, remove the
seven screws and lift off the bottom
plate.
If the belt is cracked, gouged or broken,
it should be replaced.
A new belt can be installed at your near-
est Hoover Sales and Service Center.