Filter
Top Products
6
2-2
ON/OFF pedal &
Handle release pedal
Step on pedal (A) to turn deep cleaner
on. Step on pedal again to turn deep
cleaner off.
Step on pedal (B) to lower handle to
operating position. Handle does not lock
into a single position but “floats” to allow
convenient operation.
A
B
C
D
Cleaning mode indicator
Indicator will show a green window next
to FLOOR (C) when handle is in the
operating position for cleaning carpet
rugs and bare floors.
Indicator will show a green window next
to TOOL (D) when handle is in the
upright position for tool use on stairs
upholstery etc.
Deep cleaner automatically diverts
suction from FLOOR to TOOL when
handle is raised from the operating to
the upright position.
2-3 2-4
2-5
2-6
2-7
2-8
2-9
To transport
To move your deep cleaner from room to
room put handle in upright and locked
position tilt deep cleaner back on
wheels and push forward.
The deep cleaner may also be lifted by
placing a hand under the upper clean
solution tank handle as shown.
Automatic “shut off”
When the re c o v e ry tank (lower tank) is full
the automatic shutoff mechanism will shut
o f f the deep cleaner suction (suction will
be noticeably reduced).
At that time the red float disk will rise to
the top of the recovery tank lid (E). The
deep cleaner will no longer pick up dirty
solution and the motor sound will
become noticeably higher in pitch.
When this happens turn deep cleaner
off and empty recovery tank before
continuing use.
Check clean solution tank also; it may
need to be refilled.
E
F
G
Brush speed selector
Your ‘SteamVac’ deep cleaner has three
agitator brush settings.
Hl - for normal cleaning of carpet and
bare floors
LO - for gentle cleaning of carpets and
bare floors
OFF - for cleaning carpets and bare
floors when brushing is not desired.
(Such as when picking up liquid spills.
See page 9.)
Slide selector button to the desired set-
ting before cleaning.
Brush indicator
The brush indicator will spin (F) when
the deep cleaner is turned ON and the
brushes are rotating.
If the indicator does not spin and the
pattern is visible (G) when the deep
cleaner is turned ON, the brushes are
not rotating.
There are three reasons why the brushes
may not be rotating:
1. Brush speed selector set on OFF (see
previous section).
2. Handle in upright position (see
“CIeaning mode indicator,” p. 6).
3. Brush indicator screen dirty.
H
To clean screen (H), turn deep cleaner off
and disconnect from electrical outlet.
Remove clear cover and wipe off screen
with a damp cloth. Snap cover back into
position.