Hoover Plus Carpet Cleaner User Manual


 
11
Lubrication
The motor Is equipped with bearings
which contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage. Do not
add lubricant to motor bearings.
Service
To obtain approved HOOVER service
and genuine HOOVER parts, locate the
nearest Hoover Factory Service Center
or Authorized Hoover Warranty
Service Dealer (Depot) by:
•checking the Yellow Pages under
Vacuum Cleaners - Household” OR
•checking the list of Factory Service
Centers provided with this cleaner
OR -
•calling 1-800-944-9200 for an
automated referral of authorized
service outlet locations (U.S. only)
OR-
• checking the Service section of The
Hoover Company on-line at
www.hoover.com
Please do not send your cleaner to The
Hoover Company in North Canton for
service, this will only result in delay.
If further assistance Is needed, contact
The Hoover Company Consumer
Response Center, North Canton, Ohio
44720 Phone: 1-330-499-9499.
Always identify your cleaner by the com-
plete model number when requesting
information or ordering parts. (The
model number appears on the bottom of
the cleaner.)
4. Maintenance
R e m o v a b l e
b ru s h e s
Your deep cleaner is equipped with
removable brushes for easy cleaning.
To remove bru s h e s
Disconnect cleaner from electrical
outlet.
To prevent possible leaking, remove
clean solution tank and recovery tank.
Set tanks aside.
4-1
4-2
B
B
B
A
Press handle release pedal to lower han-
dle. Turn cleaner over so bottom is fac-
ing up.
Grasp inner portion of brush (A) and pull
brush assembly out slightly to reveal
latches (B).
4-3
B
B
B
B
4-4
4-5
C
C
D
D
E
F
Press all four latches (B) and pull brush
block out. The brushes can be cleaned
under running water.
Press brush assembly firmly to snap into
place.
To replace bru s h e s
Align posts (C) on both ends of brush
assembly with slots (D) in cleaner hous-
ing.
Make sure that square post (E) also
aligns with square hole (F). Turn brush-
es slightly until post fits easily into hole.
S t o r a g e
Before storing:
Empty solution tank and rinse
thoroughly with clean water.
Replace empty solution tank and
turn deep cleaner ON. Squeeze
trigger and push deep cleaner for-
ward and back several times to
expel any solution remaining in the
deep cleaner’s system. (Do not use
deep cleaner on wood floors.)
Empty recovery tank and rinse
thoroughly with clean water.
Allow brushes and underside of deep
cleaner to air dry thoroughly before
storing deep cleaner on a carpeted or
wood surface.
Do not store deep cleaner with a full
solution tank In place.