Filter
Top Products
2. Pull or pry out end sections
as shown in illustration.
Note: Pulley end should be
removed by pulling straight out.
3. Note position of bar/brush
assemblies to insure correct
replacement.
Pull bar/brush assemblies out
of agitator slots, using pliers if
necessary.
The word “BAR” is stamped
near slots on agitator. Match
bar side of brush with “BAR” on
agitator shell. Push new
brushes all the way into slots,
tapping end lightly if necessary.
4. Line up locator on end
sections with slot on agitator.
Push end sections into position.
Screw on end plates and
tighten.
Note: If bearing should fall out
of end section during disas-
sembly of agitator, reassemble
as shown.
5. Replace belt, agitator and
bottom plate.
END SECTION
23