Filter
Top Products
Secondary filter
How to clean
Disconnect cleaner from electri-
cal outlet.
The secondary filter protects the
motor from dirt particles. If the
filter becomes dirty, either clean or
replace it.
The secondary filter is located
inside the cleaner behind the
paper bag. To remove filter, first
remove cover of cleaner, then lift
out filter. Clean filter by rinsing it
in water. When dry, slide filter
back into position.
Do not operate cleaner without
the secondary filter in place.
Rug and floor
node
To maintain cleaning effectiveness of your rug and floor nozzle, the brushes
may need to be replaced occasionally.
See your nearest Hoover factory Service Center or Authorized Warranty
Service Dealer for new brushes.
Lubrication
The motor is equipped with two bearings that contain sufficient lubrication for
the life of the motor. Addition of lubricant could cause damage. Therefore,
do not add
lubricant
to either motor bearing.