Filter
Top Products
.
0
Push plug on power nozzle cord
l
completely into cord receptacle
underneath hand grip.
Always disconnect cleaner from elec-
trical outlet before attaching or
removing power nozzle plug.
.
El
For cleaners with plastic wands,
squeeze tabs on separate cord clip
together while pressing cord into small
slot (E).
Snap one cord clip (F) onto each exten-
sion wand. Adjust cord,
placing
excess between nozzle and bottom
cord clip.
a
For cleaners with metal wands,
’
position cord into cord clips (G) on
wands, placing excess cord between
nozzle and bottom cord clip.
Note: On models with wand storage
clip,
the bottom cord clip is on the wand
storage clip.
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.
a
After assembling cleaner, plug
cord into electrical outlet. Turn
cleaner on by depressing ON-OFF
pedal (A). To turn cleaner off, depress
pedal again.
q
On models without cord rewind
pedal,
release cord by rotating
cord hook
(6)
inward before
depress-
ing ON-OFF pedal (A).
Power nozzle
The power nozzle adjusts automatically
for cleaning hard surface floors and vari-
ous heights of carpets.
It is not recom-
mended for very irregular surfaces
such as brick, slate, and certain par-
quet floors unless it is unplugged
from the cleaner.
This will stop the agi-
tator from rotating. If desired, a special
wall/floor brush (shown in “Cleaning
tools” section) can be purchased for this
task, if it is not included with your model.
Handle positions
Edge cleaning
q
The handle has two positions when
used with the power nozzle:
upright and operating.
To lower handle to operating position,
place your foot on the power nozzle and
pull handle back.
q
, Brushed edge cleaning is
provid-
ed on both sides of the nozzle to
remove embedded dirt in carpet near
baseboards and furniture. Guide either
side of nozzle parallel to edge of carpet
or furniture.