Filter
Top Products
Position hood on top of nozzle base.
Tu r n nozzle over. Replace 2 short scre w s
at the back of nozzle and 2 long scre w s
at the fro n t .
Replace brush roll cover over agitator
b r ush roll. Replace 3 short scre w s .
Lift up end of agitator brush roll. Remove
old belt from agitator pulley (E) and
replace with new belt. Lettering on belt
must be visible.
If belt is not broken but is stretched or
cut, pull it off the motor pulley (D).
Stretch belt back and attach to motor
pulley.
Hold opposite end of agitator brush ro l l
in place. Push belt end forw a rd, ro t a t i n g
end plate (F) until it slides into place.
Tu r n agitator, making sure it rotates fre e l y.
Lift off brush roll cover (C).
Remove brush roll cover (C) by remov-
ing the 3 Phillips head screws.
Return nozzle to original position and lift
off hood.
How to replace
Disconnect cleaner from electrical
outlet and disconnect power nozzle
from extension wands.
To remove hood, turn nozzle over and
unscrew the 4 recessed Phillips head
screws.
Note: Do not remove the 3 screws in
the triangle formation as these hold
the motor in place.
9
3 - 9
3 - 1 0
3 - 1 3
3 - 1 1
3 - 1 2
3 - 1 4
3 - 1 5
3 - 1 6
3 - 1 7
D
C
E
F
C
C