Filter
Top Products
6
2-1
The assembled cleaner will look like
this drawing.
1. Hand grip
2. Solution trigger: squeeze to
release clean solution.
3. Brush control switch: lowers
the brush assembly for wet clean-
ing or raises the brush assembly
for wet pickup and dry vacuum-
ing.
4. Clean solution tank release
5. Clean solution tank cap/
measuring cup
6. Clean solution tank
7. ON/OFF switch
8. Recovery tank lid and filter
9. Recovery tank release
10. Recovery tank: Collects dry
debris as well as dirty cleaning
solution.
11. Wet/Dry pedal: Press pedal to
change between wet and dry
cleaning.
12. Wet/Dry indicators: Shows
either wet or dry cleaning usage.
13. Nozzle release buttons:
Release nozzle for easy clean-up.
14. Nozzle
15. Squeegee
16. Handle release pedal
17. Cord hooks: Top hook rotates
for quick cord release.
18. Carrying handle
19. Soft-tread wheels
2. How to use
This cleaner is intended for house-
hold use.
Operate cleaner only at voltage
specified on data plate on back of
cleaner.
Plug cleaner into a properly
grounded outlet.
2
11
4
9
16
12
7
13
13
14
15
10
8
3
5
1
16
17
19
18
5
Continued
2-3
2-2
2-4
ON/OFF Switch
Push switch (B) up to turn cleaner on.
Push switch down to turn cleaner off.
Handle Release Pedal
Step on pedal (A) to lower handle to
operating position. Handle does not
lock into a single position but “floats”
to allow convenient operation.
To transport
To move your cleaner from room to
room, put handle in upright position;
tilt cleaner back on rear wheels and
push forward.
A
B