Filter
Top Products
I
7
2-12
2-13
Turn cap (H) upside down to serve
as a measuring cup.
2-10
Using cap, measure 2 oz. of applica-
ble concentrate formulated for use
with the ‘FloorMate’ hard floor cleaner.
2-11
Pour detergent into tank. Fill tank to
fill line (I) (1 quart) with warm water.
If rubber ring (J) on cap has become
dislodged, reposition it with uneven
side against ledge (K) as shown.
Use Machine Formula OLD ENG-
LISH® Wood Floor Cleaning Concen-
trate for wood floors when cleaning
laminate wood, polyurethane sealed
wood or other wood floors that can
normally be cleaned using water.
Check for worn spots or joint separa-
tions before using, as these condi-
tions could lead to damaged flooring
when using water to clean floor.
Both of these detergents have been
specifically formulated to resist
excessive foaming and other undesir-
able effects when used in your ‘Floor-
Mate’ cleaner.
DO NOT use detergents that con-
tain pine or solvent based ingredi-
ents.
K
J
H
For best results, use Machine Formula
LYSOL® Floor Cleaning Concentrate
when cleaning floor surfaces such as
vinyl, ceramic and other tiles, and
linoleum.
Continued
CAUTION: Machine Formula
LYSOL® Floor Cleaning Concen-
trate and OLD ENGLISH® Wood
Floor Cleaning Concentrate cannot
be used in Hoover SteamVac™
products. Doing so could damage
your SteamVac™.
Replace cap. Rotate cap clockwise
until it locks in place. Cap must be
locked in place for proper perfor-
mance and to prevent leaking.
2-14 2-15
Recovery Tank (lower tank)
The recovery tank holds both dry
debris and dirty cleaning solution that
is picked up from the floor surface.
Automatic Shut-Off (WET mode)
When the recovery tank is full, the
automatic shut-off will shut off the
cleaner’s suction (suction will be
noticeably reduced).
At that time, the cleaner will no longer
pick up dry debris or dirty solution
and the motor sound will become
noticeably higher in pitch.
When this happens, turn the cleaner
off and empty the recovery tank
before continuing use.
If using cleaner for wet cleaning,
check the solution tank; it may need to
be refilled also.
Position bottom of tank into cleaner.
Press latch and snap tank into place.