Filter
Top Products
Note location of tapered rails (J) on
dirt cup support (K) and on lower
handle.
3
Rotate cord protector (F) as shown.
With (F) pointing downward (toward
back of handle), press groove (H) into
slot (I).
Pull cord tight.
Step 3 Attach dirt
cup assembly
Release dirt cup latches (A) by
pulling them outward.
Remove cup and set it aside.
Slide extensions (B) on lower back
of cloth bag into slots (C) in lower
handle.
1-4
1-5
1-7
1-8
H
I
F
F
H
F
B
B
C
D
C
A
E
F
G
J
K
L
M
I
Press cord into place at each of the
three notches indicated and note
correct positioning of (F).
Do not plug cleaner in until
assembly is totally complete.
1-6
Insert the two screws at area shown (D).
Tighten screws.
Note round opening (E) and hooks (F)
on back of cloth bag. Place opening
over dirt tube (G).
Press down firmly to snap hooks
into handle.
On upper handle, grasp bag clip
retainer (H) and pull down firmly.
Hook bag clip (I) into slot in retainer.
1-9
1-10
1-11
1-12
1-13
F
UP
Step 4 Attach handle
Slide rails on support onto rails (L)
on lower handle until support snaps
past the lock tab (M).
Continued
➜
Note proper placement of
cord at notch as shown.