Filter
Top Products
ON-OFF switch
The ON-OFF switch (A) is located on the
cleaner body. Turn the cleaner ON by
pressing the switch to ❙ for BARE FLOOR
or to ❙❙ for CARPET. Turn the cleaner OFF
by pressing the switch to O.
3-4
Pull filter (C) inside out through filter
frame.
C
4
2-1
2-3
2-2
3-1
3-2
3-3
A
B
C
D
2. How to use
Cleaning under low
furniture
Your cleaner has been designed to do an
effective job cleaning under low furniture
and in hard to reach areas. Lower handle
to floor level and proceed with back and
forth motion.
Storing cleaner
When cleaner is not in use, wrap cord
around cord hooks as shown. Upper hook
rotates for quick release.
For your convenience, cleaner may be
hung on a hook from opening at top of
handle. Cleaner can also stand in the
upright position.
Familiarize yourself with these home main-
tenance tasks as proper use and care of
your cleaner will ensure continued clean-
ing effectiveness.
Dirt cup
The dirt and debris picked up by the
cleaner is deposited into the dirt cup. It
is recommended that the dirt cup be
emptied after each use.
Very fine materials, such as face pow-
der, cornstarch and fireplace ashes,
picked up in large quantities can cause
a loss of suction. When using the
cleaner for this type of dust, empty cup
often.
When empty, the cup can be cleaned with
a damp cloth or rinsed with water. Be
sure cup is dry before reusing.
How to empty dirt cup
Disconnect cleaner from electrical
outlet.
Press dirt cup latch (A) down and pull
cup (B) out.
Hold cup over trash can.
Remove filter (C) from top of cup.
Empty cup, making sure to hold cup with
dirt port (D) facing up.
Shake dust from filter.
Operate cleaner only at voltage speci-
fied on data plate located on back of
cleaner motor housing.
Polarized plug
To reduce the risk of electric shock, this
product has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the
plug does not fit in the outlet, reverse the
plug. If it still does not fit, contact a quali-
fied electrician to install the proper outlet.
Do not change the plug in any way.
Plug cord into electrical outlet. Your
cleaner is now ready to operate.
3. Maintenance
A