Filter
Top Products
UP
Place upper (B) and lower (C) handle sections on a flat
surface with cord hooks (A) on top. With hands on sides of
handle sections, push handle sections together firmly until
they “click” into place.
Do not press against the rod (D) extending from the lower
handle. If the rod breaks or bends, the cleaner will not
work properly. Do not push handle together with your
hands on the ends of the sections.
3
A
D
D
Step 2 Attach cord
Note: The small red tab (E) above the ON/OFF switch (F) is for shipping
purposes only and may fall off during assembly. If it does not fall off, the tab
will be removed during the final steps of assembly.
Turn handle over. Insert large rectangular end of cord into pocket in bottom of
handle, with side marked “UP” visible.
Make sure rectangular end is pushed into handle as far as possible.
Slide cord protector (G) toward upper handle (B).
Rotate cord protector (G) as shown
(toward back of handle).
With (G) pointing downward, press groove (H) into
slot (I).
Pull cord tight.
3
Press cord into place at each of the three notches indi-
cated and note correct positioning of (G).
Do not plug cleaner in until assembly is totally
complete.
Step 1 Assemble handle
6
UP
Continued
➜
A
B
“UP”
G
C
F
E
B
G
C
2
4
5
G
G
H
I