Filter
Top Products
G
Remove lens - Disconnect clean-
er from electrical outlet.
Using a screwdriver, remove the two
screws as shown and lift off lens.
3-16
3-15
10
Secondary and final
filters
Cleaning secondary filter
Disconnect cleaner from electrical
outlet.
The secondary filter (G), located under-
neath the retainer in the bottom of clean-
er cavity, protects the motor from dirt
particles.
If filter becomes dirty, remove dirt cup
(Fig. 3-2). Remove screw and pull
retainer out. Lift out filter.
Hand wash filter in cold water with mild
detergent, then air dry.
Reposition dry filter, retainer and screw.
Replace dirt cup.
Should you want to replace this filter, ask
for HOOVER part No. 38765019.
3-13
Cleaning final filter
The final filter assists in returning clean
air to the room.
To remove this filter when it becomes
dirty, remove dirt cup and pull down top
of filter.
Check agitator shield
Because your cleaner picks up so well,
we strongly recommend you check for
debris accumulation under the agitator
shield each time you clean the filters.
Removing debris under the shield will
help maintain your cleaner’s excellent
pick up and suction. Remove debris as
follows:
1. Disconnect cleaner from electrical
outlet.
2. Check for dirt accumulation by remov-
ing bottom plate (Fig. 3-18), removing
agitator (Fig. 3-19), and lifting agitator
shield (Fig. 3-22).
3. Remove any debris and replace
shield, agitator and bottom plate (Figs.
3-22 to 3-24).
3-14
Removing and replacing filter
Lift out filter (H) and hand wash it in cold
water with mild detergent.
Let filter air dry and reposition it on the
side of cleaner.
Reposition dirt cup.
Should you want to replace this filter, ask
for HOOVER part No. 40110004.
Do not operate cleaner without any of
the filters in place.
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base
type 912 bulb, HOOVER part No.
27313101.
Install bulb - Pull old bulb straight
out of socket. Push new bulb straight
into socket until locked in place
Excessive force is not required.
H
3-12