Hoover 500 Vacuum Cleaner User Manual


 
17
To remove tank, squeeze release button
and pull tank straight out.
18
Carry tank to a sink.
Rotate tank cap counter-clockwise and
lift up to remove cap (A).
19
Turn cap (A) upside down to serve as a measuring
cup.
For hard surface floors such as vinyl, linoleum, marble,
laminate wood, polyurethane sealed wood or other wood
floors that can normally be cleaned using water, use one
cup (2 oz.) HOOVER® Floor to Floor™ Cleaner.
Check for worn spots or joint separations before using,
as these conditions could lead to damaged flooring when
using water to clean floor.
When cleaning ceramic and other tiles, use the set of
grout brushes with gray bristles included with your
FloorMate™ SpinScrub™ 500 Cleaner. Use these for tile
floors where extra attention is needed for cleaning grout.
(See “Cleaning the brushes” section for how to remove
and replace the brush assemblies.)
Using cup, measure 1-1/2 cupfuls (3 oz.) of HOOVER®
Grout Cleaner.
Solution (upper) tank
The solution tank holds detergent and water that is to be dispersed onto the
surface being cleaned.
How to fill
Disconnect cleaner from electrical outlet.
Place cleaner handle in upright, locked position.
The tanks
9
Continued
17
18
19
A
A