Filter
Top Products
Troubleshooting
What’s the problem? What to do
Cleaner won’t run ✓ Make sure the cleaner is
plugged in firmly.
✓ Check the fuse or breaker.
Low suction ✓ Empty the recovery tank; it may be full
and the automatic shut-off engaged.
✓ Make sure filter and filter lid are properly
positioned.
✓ Make sure tanks are locked in place.
✓ Check the filter and clean if dirty.
✓ Make sure nozzle is replaced properly
and locked.
Water puddling behind cleaner ✓ Use recommended detergents to reduce
excess foaming.
✓ Make sure solution tank is installed
properly.
✓ Empty recovery tank.
Won’t pick up dirty solution ✓ Check Mode selector dial to ensure it is
set for WET PICKUP.
✓ Make sure recovery tank is installed
properly.
✓ Empty recovery tank.
✓ Make sure filter and filter lid are properly
positioned.
Cleaner pushes a line of dry debris ✓ Check Model selector dial to ensure it is
in front of it set for DRY VAC.
✓ Tip nozzle off floor by pushing down on
handle to pick up debris that is too large
to clear the squeegee.
Cleaning solution won’t dispense ✓ Make sure solution tank is locked in
position.
✓ Refill the solution tank if it is empty.
Brushes won’t rotate ✓ Check Mode selector dial to ensure it is
set for WASH.
✓ Reset circuit breaker.
(1) Push ON/OFF switch to turn cleaner
OFF.
(2) Unplug the cleaner.
(3) Wait one minute.
(4) Plug the cleaner into electrical outlet.
(5) Push the ON/OFF switch again to
turn cleaner ON.
If the brushes continue to stall and the
breaker trips again, clean the brushes to
remove debris.
17
Use the list below to help solve minor problems.
Continued
➜