Filter
Top Products
WARNING: To reduce the risk of injury,
unplug the vacuum cleaner before servicing.
PROBLEM: Vacuum cleaner won’t run
Cause: Not properly plugged into
electrical outlet
Solution: Plug unit in firmly.
Cause: Vacuum cleaner not turned on.
Solution: Press on/off button.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum
cleaner. Leave for one (1) hour. See page 2.
PROBLEM: Cleaner won’t pick up/
loss of suction
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Dust bag full or blocked.
Solution: Replace dust bag. Empty/clean/
replace cloth bag
Cause: Clogged filter.
Solution: Remove/replace with new filter
VCC-05. Remove wash/replace HEPA filter
VCC-07.
Cause: Blockage in hose.
Solution: Disconnect hose, remove the
obstruction then re-fit.
PROBLEM: Accessories won’t pick up
Cause: Accessories are not attached
correctly.
Solution: Refer to page 5 for fitting
information.
PROBLEM: Dust escaping from the
vacuum cleaner
Cause: Dust bag full.
Solution: Dispose of paper dust bag, replace
with a new one or empty/clean/replace
cloth bag.
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Hose is not installed correctly.
Solution: Review hose installation.
Cause: Filter not installed completely.
Solution: Review filter removal and
replacement.
9. TROUBLESHOOTING
Voltage: 220-240V~50Hz
Wattage: 1400W Model VCC-05
1500W Model VCC-07
Capacity: 6 litres max Model VCC-05
8 litres max Model VCC-07
Filters: Pre-motor filter VCC-05 only
HEPA Model VCC-07 only
Cord length: 12 metres
Weight: 7.2kg Model VCC-05
8.5kg Model VCC-07
Subject to technical change without notice.
8. TECHNICAL SPECIFICATION
1312